The primary reason for this release is that there was a bug in 1.1.1245 that prevented Z-Wave 'reset network' from working, and some users got stuck with a "failled to start z-wave" error.
1. Add default values for sensors as not-tripped so it appears correctly in the UI when the sensor hasn't been used yet.
2. Add support for multi-channel association
3. Add support for Danfoss thermostat
4. Fix for X10 devices that have 2 digit numeric ID's
5. Add support for Everspring motion sensors
6. Add support for Aeon 4-in-1 sensors
7. Minor enhancements to the wakeup procedure to support devices with short wakeup times
8. Fix support for the gc-100
9. Add support for the PolyControl door lock
10. Change the default PIN for locks to 8 characters instead of 4
Comments
0 comments
Please sign in to leave a comment.